Can I learn the ip-address of the person whose comment is in my blog?
'95 Saturn SC2 with codes 19, 26 and 32
Hello Guest		   
  • Login
• Register…
• Start blog		   • Who, Where, When
• What is interesting here?
• Duels		   • Polls
• Avatars
• Interests		   • Cities and Countries
• Random blog
• Users search		   • Search
• Games
• Tests
• CarGuru		   • Ñîîáùåñòâà
• Talxy Chat
• Horoscope
• Online		  
Register!
CarGuru > Saturn > '95 Saturn SC2 with codes 19, 26 and 32 8 March 2005 06:08:21
  Recent blog posts: 
starting issue, 2002 dodge…
My 2002 Dodge Caravan wouldn't crank. I tested some things, replaced the battery. After installing the…

1988 Ford F-150 Truck
I would like to remove the pollution control system from my 1988 F-150, 4.9L I6 300 4x4. Can anyone…

my 99 M chrysler has started to…
my 99 M chrysler has started to cool and then starts to give off heat in the ac vents and then cool…

;-)
;-)­

dodge 2000 intrepid
bought this car right off the show room floor in Bartow fl to this date I have not had any work done on…

Que pour la place trange
Que pour la place trange

Saturn Sky Red Line
I just purchased a 2007 Saturn Sky Redline. I noticed will driving yesterday that when I turned on the…

Coolant temp on Saturn Sky
I just purchased a 2007 Saturn Sky Redline. As I was driving yesterday I happen to have the info set on…

gandon.......
gandon.......

you
you

  Forums:   
    topic feeds

• CarGuru  all topics, blogs and comments

• Driving

• Formula-1

• Indycar

• Nascar

• Other sport

• Technology

• 4 x 4

• Volkswagen

• Mercedes

• Acura

• Alfa-romeo

• Audi

• BMW

• Chrysler

• Dodge

• Ford

• General Motors

• Jeep Willys

• Honda

• Hyundai

• Mazda

• Nissan

• Peugeot

• Pontiac

• Porsche

• Saab

• Saturn

• Toyota

• Volvo

• Buy / Sell

• Open discussion

• Anonymous
  Discuss: 
Monroe ceramic brake pads any…
They are running a promotion with a $20 rebate. Are the ceramic pads any good? This is for normal…

Schematic for 98 SL2? 10 amp…
I have a 1998 SL2 and the 10 amp body fuse blows. Tried a 20 amp (danger!) and it immediately blew…

Re: Alternator whine problem.
Sometimes you have to look at what makes the bearings fail, like an off balance rotor due to dirt or…

Re: Saturn loosing oil?
"lbbss" <labicff@yahoo.com>­ wrote in message…
  Recent forum topics: 
mazda premacy glowplug lights…
i have a mazda premacy 2litre diesel . have a problem at the moment ,glowplug light flashing with loss…

I have a 96 chrysler new york…
I have a 96 chrysler new york lhs but no owners manuel and on the message center there is a light that i…

...96 Accord tranny issue
I have a 1996 honda accord ex automatic. on a cold start the car shits gears realitively fine. however…

i just want to find out how…
i just want to find out how much it will cost to change an ignition to a 2001 pontiac grand am and can i…
  Recent forum comments:
RE: stuck hatchback
just my latch is stuck and the door wont close on my 2000 sub outback limited

RE: stuck hatchback
on the rear gate that is

RE: 2001 PT Cruiser Problems??????
lor

RE: turn signal problams
Try a new flasher because it's cheaper. If that doesn't work then you probably need a new turn signal…

RE: Re: Road test - DMV is cracked
Well, I passed on the 4th roadtest. The examiner said I should have passed it the first time. I have…

RE: Still trying to find an NB…
Anon wrote: I got the real thing last year for $55 from Trussville Mazda…

RE: Re: 1996 neon problems.. :(
no spark

RE: Re: Transmission shudder when…
I can feel something like a kick when I first hit the gas pedal when I take off.

RE: Re: Transmission shudder when…
who are you speaking to

RE: How to duplicate Navtech CD’s
where can i buy nav cd's for a 2003 s class mercedes also the latest version for a 2005 sl?
  Ìîäåðàòîð:
 Administrator

'95 Saturn SC2 with codes 19, 26 and 32

Bill 13 February 2005 00:11:13
 Hello all,

My daughter just dropped off her '95 SC2 for me to fix up and I have a
couple of questions. I flashed the codes and got 19, 26 & 32. From what
info I've found in past posts, 26 & 32 are probably both pointing to
the problems in my EGR or Canister solinoids. I'm about to go check
that.

I have found no useful information on code 19, though. Does anyone have
any pointers? I haven't driven the car enough to verify everything, but
over all it seems to run okay.

Thanks for your Help!

Bill

Add comment
Semi Head 21 February 2005 14:15:22 [ permanent link ]
 From: btcat@sbcglobal.net­ (Bill)
I have found no useful information on >code 19, though. Does anyone have any >pointers? I haven't driven the car >enough to verify everything, but over all >it seems to run okay. >

Wolfman writes:

Code 19= "6x signal fault" The 6x signal is sent from the CPS
(crankshaft position sensor) and used by the PCM and DIS
(distributorless igniton module) to set ignition timing. An intermittant
6x signal fault is generally caused by loose or back wiring or connector
at the CPS or a CPS on it's way out. (About a $15 part)

Add comment
Bill 27 February 2005 06:29:22 [ permanent link ]
 I checked my CPS. It was on the high end of the spec, to I replaced it
and inspected all wiring. Still, after about 15 seconds of running,
code 19 comes back and the SES light comes on. The engine runs fine.

I also have an extra PCM which I have used as a test. It logs 19 also.
Any suggestions?

The other two codes also keep recurring. I suspect the purge control
solinoid is the culprit for the 26 code. All hoses, wiring etc. look
good.

This car will not pass state inspection with the SES on and stored
Emmisons codes.

Add comment
B. Peg 27 February 2005 22:26:09 [ permanent link ]
 I seem to recall 19 was the purge solenoid. However, it turned out to be a
cracked vacuum hose at the rear of the engine (twin cam) and not the valve
itself. I couldn't get to it as it was a hoist job.
The 32 is probably the EGR valve which you may be able to clean and degunk.
Dunno about the 26 though.

B~


Add comment
Bill 8 March 2005 06:08:21 [ permanent link ]
 Update: On the code 19, I finally found the culprit. The 6x ref. wire
(or something like that) coming from the coilless ignition system (CIS)
and going to the PCM was bad. I replaced the wire and the code went
away. Unfortunately, so did my tach. This is the part that doesn't make
sense to me. I hooked the original 6x ref. wire to the new wire at the
CIS, no code and the tach works. The original wire must be bad before
the tach signal wire breakout.

The code 26 is still a problem. I ordered a new Canister Purge Solinoid
today and will get it tomorrow. Seems like all this is taking forever,
but I only have short periods of time to work on it.

Thanks for all the free advise. Maybe the above will help someone else
sometime. BTW, the Hayes manual is wrong about the Tach wire and the
DIS.

Bill

Add comment
 

Add new comment

As:
Login:  Password:  
 
 
  
 
respect your talk pals, avoid using obscene language, typing entire messages in CAPS, posting buy/sell ads or violating netiquette or the RF Criminal Code..

CarGuru > Saturn > '95 Saturn SC2 with codes 19, 26 and 32 8 March 2005 06:08:21
see also:
NASCAR-ELITE: SES: Countdown to the…
NASCAR-BUSCH/ASA: Stephen Leicht update…
WRC: Rally Catalunya: Chris Atkinson…
pass tests:
see also:
BMW 2001 325I
keyless remote
FUEL INJECTORS
  Copyright © 2001—2009 Car-Guru
Idea: Miñhael Monashev
See Help and FAQ in the community support.car-guru.com.
Write in the community about the bugs you have noticedbugs.car-guru.com.
Write your offers and comments in the communities suggest.car-guru.com.
Information for parents.
Write us at:
If you would like to report an abuse of our service, such as a spam message, please .