The Fix, Been There

Recent blog posts:

95 mirage
I have a 95 mirage and this is the second time the injector in number 3 cylinder has gone bad. Anything…

1988 Ford F-150 Truck
I would like to remove the pollution control system from my 1988 F-150, 4.9L I6 300 4x4. Can anyone…

my 99 M chrysler has started to…
my 99 M chrysler has started to cool and then starts to give off heat in the ac vents and then cool…

dodge 2000 intrepid
bought this car right off the show room floor in Bartow fl to this date I have not had any work done on…

starting issue, 2002 dodge…
My 2002 Dodge Caravan wouldn't crank. I tested some things, replaced the battery. After installing the…

;-)
;-)

stereo pin
I put a new battery in my girl friends 94 900 and it wants a code for the radio. There is nothing in the…

Coolant temp on Saturn Sky
I just purchased a 2007 Saturn Sky Redline. As I was driving yesterday I happen to have the info set on…

Saturn Sky Red Line
I just purchased a 2007 Saturn Sky Redline. I noticed will driving yesterday that when I turned on the…

Que pour la place trange
Que pour la place trange

They have birthday today:

Esther

all >>

Forums:

topic feeds

• CarGuru all topics, blogs and comments

• Driving

• Formula-1

• Indycar

• Nascar

• Other sport

• Technology

• 4 x 4

• Volkswagen

• Mercedes

• Acura

• Alfa-romeo

• Audi

• BMW

• Chrysler

• Dodge

• Ford

• General Motors

• Jeep Willys

• Honda

• Hyundai

• Mazda

• Nissan

• Peugeot

• Pontiac

• Porsche

• Saab

• Saturn

• Toyota

• Volvo

• Buy / Sell

• Open discussion

• Anonymous

Discuss:

Pulse in Engine RPM
there is a pulse in RPM's at certain speeds....usually around 50.... be driving, then a pulse of a gain…

1994 JEEP GRAND CHEROKEE…
Hi, I am the owner of a 1994 jeep grand cherokee limited runs good when it starts but has problems.I…

Grand Cherokee oil level…
Just added a second jeep to the drive, a 1993 grand (ZJ??), anyways the only fault it has is that the…

who are the best posters in…
the best was clearly biil hughes his invice was always the most useful bt he got run off the worst are…

Recent forum topics:

Brake Lights won't work
brake lights on 1996 Grand Am won't work. Fuse and lights are fine. Suggestions?

honda civic 87 model problem
i would like some information on why my honda civic wont start at times after its hot when running it…

mazda premacy glowplug lights…
i have a mazda premacy 2litre diesel . have a problem at the moment ,glowplug light flashing with loss…

I have a 96 chrysler new york…
I have a 96 chrysler new york lhs but no owners manuel and on the message center there is a light that i…

Recent forum comments:

RE: Ask How To Replace Headlight…
how do I release the locking ring on the headlamp bulb in a 99 dodge ram 2500?

RE: Re: Transmission shudder when…
who are you speaking to

RE: Re: Transmission shudder when…
I can feel something like a kick when I first hit the gas pedal when I take off.

RE: stuck hatchback
on the rear gate that is

RE: stuck hatchback
just my latch is stuck and the door wont close on my 2000 sub outback limited

RE: 1999 Chrysler T&C - Speed…
I am reading all of this and am amazed at how bad I am getting ripped off by my Chrysler dealership....4…

RE: How to duplicate Navtech CD’s
where can i buy nav cd's for a 2003 s class mercedes also the latest version for a 2005 sl?

RE: Heating problem in 1988 Honda…
well thats no always true!!! my husband replaced the thermostat/thermometer..... and the water…

RE: Mitsubishi Diamante ECU faults…
how did you read the codes

RE: 98 Dodge Grand Caravan Problems
I had the same problem with the instrument panel, after about a months worth of greif, and dollars…

Модератор:

Administrator


The Fix, Been There
Mindy 28 April 2005 02:35:07
	Buy a new back light assembly for the side that is giving problems for 150 dollars and your problem is solved or better yet try the junk yard.....It is the bulb holders piece that has gotten hot and melted and preventing good contact.....you cant and I repeat cant buy the bulb holder assembly by itself even though it has screws to remove just that part that is causing the trouble.....I was denied warranty due to it being apart of a cosmetic part......trust me, I know, I have battled this problem.....good luck...quick way to test is switch assemblies from the good side and you will see problem solved...... "James" <jnipperxxx@nospamfdn.com> wrote in message news:kKadnfOm256_nvbfRVn-3A@comcast.com...> Brake lights work fine, when neither the parking lights or headlights are> on.> When either the parking lights or headlights are turned on, the left> brakelight goes off !!!> I have put brand new bulbs in left/right/upper-center brakelight housings.> Again, the brake lights operate ok, as long as I don't have the headlights> or the parking lights on. The minute I turn either of them on, the LEFT> brake light will not work !!! This is truly weird.> Can anyone help me ???> Thanks !!> --James-->
		Add comment


L . W . Hughes III 28 April 2005 02:45:14 [ permanent link ]
	For a hundred and fifty bucks, I could do a lot of revamping. God Bless America, Гџill O\|\|\|\|\|\|\|O mailto:LWHughes3rd@aol.com http://www.billhughes.com/ Mindy wrote:> Buy a new back light assembly for the side that is giving problems for 150> dollars and your problem is solved or better yet try the junk yard.....It is> the bulb holders piece that has gotten hot and melted and preventing good> contact.....you cant and I repeat cant buy the bulb holder assembly by> itself even though it has screws to remove just that part that is causing> the trouble.....I was denied warranty due to it being apart of a cosmetic> part......trust me, I know, I have battled this problem.....good> luck...quick way to test is switch assemblies from the good side and you> will see problem solved......
		Add comment


Matt Macchiarolo 28 April 2005 03:48:06 [ permanent link ]
	Heck yeah. Doesn't seem like it would be too difficult to just take the internals of a trailer tailight and install the bulb holder from that into the GC taillight assembly. "L.W. ("Яill") Hughes III" <billhughes@cox.net> wrote in message news:427015FA.91E91427@cox.net...> For a hundred and fifty bucks, I could do a lot of revamping.> God Bless America, Яill O\|\|\|\|\|\|\|O> mailto:LWHughes3rd@aol.com http://www.billhughes.com/> Mindy wrote:>> Buy a new back light assembly for the side that is giving problems for >> 150>> dollars and your problem is solved or better yet try the junk yard.....It >> is>> the bulb holders piece that has gotten hot and melted and preventing good>> contact.....you cant and I repeat cant buy the bulb holder assembly by>> itself even though it has screws to remove just that part that is causing>> the trouble.....I was denied warranty due to it being apart of a cosmetic>> part......trust me, I know, I have battled this problem.....good>> luck...quick way to test is switch assemblies from the good side and you>> will see problem solved......
		Add comment


L . W . Hughes III 28 April 2005 04:59:08 [ permanent link ]
	And driving sixty, fifty, and thirty year old cars, I'm forced to do it all the time. God Bless America, Гџill O\|\|\|\|\|\|\|O mailto:LWHughes3rd@aol.com http://www.billhughes.com/ Matt Macchiarolo wrote:> Heck yeah. Doesn't seem like it would be too difficult to just take the> internals of a trailer tailight and install the bulb holder from that into> the GC taillight assembly.
		Add comment


Mike Romain 28 April 2005 17:12:02 [ permanent link ]
	You 'can' buy replacement pigtails that you can put in. I used them in all my light fixtures when I rebuilt my CJ7. They are inexpensive unfortunately, I would have preferred higher quality parts, but 5 years later they all are still working. Mike 86/00 CJ7 Laredo, 33x9.5 BFG Muds, 'glass nose to tail in '00 88 Cherokee 235 BFG AT's Matt Macchiarolo wrote:> Heck yeah. Doesn't seem like it would be too difficult to just take the> internals of a trailer tailight and install the bulb holder from that into> the GC taillight assembly.> "L.W. ("Гџill") Hughes III" <billhughes@cox.net> wrote in message> news:427015FA.91E91427@cox.net...> > For a hundred and fifty bucks, I could do a lot of revamping.> > God Bless America, Гџill O\|\|\|\|\|\|\|O> > mailto:LWHughes3rd@aol.com http://www.billhughes.com/> > Mindy wrote:> >> Buy a new back light assembly for the side that is giving problems for> >> 150> >> dollars and your problem is solved or better yet try the junk yard.....It> >> is> >> the bulb holders piece that has gotten hot and melted and preventing good> >> contact.....you cant and I repeat cant buy the bulb holder assembly by> >> itself even though it has screws to remove just that part that is causing> >> the trouble.....I was denied warranty due to it being apart of a cosmetic> >> part......trust me, I know, I have battled this problem.....good> >> luck...quick way to test is switch assemblies from the good side and you> >> will see problem solved......
		Add comment




Get comments by e-mail Add to favourites

respect your talk pals, avoid using obscene language, typing entire messages in CAPS, posting buy/sell ads or violating netiquette or the RF Criminal Code..

	see also: Re: OT : Top Gear vs 5th Gear Two Questions [OT] Shtop...		pass tests:		see also: 1988 JEEP/CHEROKEE/LADERO ACCIDENT Removal of Rear Caliper Audi A4 1997 Engine Control Computer

The Fix, Been There

Add new comment