99 Intrepid Door Locks

Recent blog posts:

95 mirage
I have a 95 mirage and this is the second time the injector in number 3 cylinder has gone bad. Anything…

1988 Ford F-150 Truck
I would like to remove the pollution control system from my 1988 F-150, 4.9L I6 300 4x4. Can anyone…

my 99 M chrysler has started to…
my 99 M chrysler has started to cool and then starts to give off heat in the ac vents and then cool…

dodge 2000 intrepid
bought this car right off the show room floor in Bartow fl to this date I have not had any work done on…

starting issue, 2002 dodge…
My 2002 Dodge Caravan wouldn't crank. I tested some things, replaced the battery. After installing the…

;-)
;-)

stereo pin
I put a new battery in my girl friends 94 900 and it wants a code for the radio. There is nothing in the…

Coolant temp on Saturn Sky
I just purchased a 2007 Saturn Sky Redline. As I was driving yesterday I happen to have the info set on…

Saturn Sky Red Line
I just purchased a 2007 Saturn Sky Redline. I noticed will driving yesterday that when I turned on the…

Que pour la place trange
Que pour la place trange

They have birthday today:

Lee Baldwin

jose vazquez

Arthur

all >>

Forums:

topic feeds

• CarGuru all topics, blogs and comments

• Driving

• Formula-1

• Indycar

• Nascar

• Other sport

• Technology

• 4 x 4

• Volkswagen

• Mercedes

• Acura

• Alfa-romeo

• Audi

• BMW

• Chrysler

• Dodge

• Ford

• General Motors

• Jeep Willys

• Honda

• Hyundai

• Mazda

• Nissan

• Peugeot

• Pontiac

• Porsche

• Saab

• Saturn

• Toyota

• Volvo

• Buy / Sell

• Open discussion

• Anonymous

Discuss:

I have a 96 chrysler new york…
I have a 96 chrysler new york lhs but no owners manuel and on the message center there is a light that i…

1999 Chrysler T&C - Speed…
Hi, Just four months ago, in December I wrote about the speed sensor problem in my 1999 T&C in…

How to clean cloth upholstery
I have a '95 LeBaron with cloth upholstery, mostly tan with some black woven in and maybe another color…

2002 Voyager Drain Plug…
Need help locating radiator drain plug for 2002 Voyager. Would appreciate someone sending back location…

2001 PT Cruiser Problems??????
Recently bought one. Love it! Anything in particular I should watch for? Anybody have anything…

Recent forum topics:

mazda premacy glowplug lights…
i have a mazda premacy 2litre diesel . have a problem at the moment ,glowplug light flashing with loss…

I have a 96 chrysler new york…
I have a 96 chrysler new york lhs but no owners manuel and on the message center there is a light that i…

...96 Accord tranny issue
I have a 1996 honda accord ex automatic. on a cold start the car shits gears realitively fine. however…

i just want to find out how…
i just want to find out how much it will cost to change an ignition to a 2001 pontiac grand am and can i…

Recent forum comments:

RE: Ask How To Replace Headlight…
how do I release the locking ring on the headlamp bulb in a 99 dodge ram 2500?

RE: Re: Transmission shudder when…
who are you speaking to

RE: Re: Transmission shudder when…
I can feel something like a kick when I first hit the gas pedal when I take off.

RE: stuck hatchback
on the rear gate that is

RE: stuck hatchback
just my latch is stuck and the door wont close on my 2000 sub outback limited

RE: 1999 Chrysler T&C - Speed…
I am reading all of this and am amazed at how bad I am getting ripped off by my Chrysler dealership....4…

RE: How to duplicate Navtech CD’s
where can i buy nav cd's for a 2003 s class mercedes also the latest version for a 2005 sl?

RE: Heating problem in 1988 Honda…
well thats no always true!!! my husband replaced the thermostat/thermometer..... and the water…

RE: Mitsubishi Diamante ECU faults…
how did you read the codes

RE: 98 Dodge Grand Caravan Problems
I had the same problem with the instrument panel, after about a months worth of greif, and dollars…

Модератор:

Administrator


99 Intrepid Door Locks
Dan 24 April 2005 18:40:01
	I am getting ready to rip into the passenger door and fix a problem with the power door lock. Before I start, I want to run this by the brains of this news group. The problem I have is the door will not unlock, but does lock when the button is pushed. During the lock/unlock selections, a loud "screeching" sound comes from the door. Interesting, I have a neighbor with a Neon that appears to have the same problem as I do, and a friend at work that has an Intrepid with the same issue, so I am assuming this may be a chronic problem, and if it is, I know someone reading this must have come across this before. So, in my quest for making my repair time more efficient, I am looking for experience readers to enlighten me what is broke. It sure would make my repair time quicker as I can have the parts ready to go, and an attack plan of exactly what I am going to replace. Thanks all. Dan
		Add comment


MoPar Man 24 April 2005 19:53:36 [ permanent link ]
	Dan wrote: I am getting ready to rip into the passenger door and fix a > problem with the power door lock.> The problem I have is the door will not unlock, but does lock> when the button is pushed. During the lock/unlock selections,> a loud "screeching" sound comes from the door. See my posts in rec.autos.makers.chrysler between Jan 31 to Feb 4, 2004. I have a 2000 300M, and initially my rear driver-side door couldn't be unlocked or opened for a few days. Someone mentioned a child safety lock may have inadvertently been engaged, but that was no the case. It became operational on it's own a few days later, then one day during it's normal auto-locking behavior it buzzed real loud and I practically jumped out of my skin when it happened. Took it to a dealer and got it replaced: Here is an exerpt: Subject: Re: Chrysler 300M: Can't open rear passenger door Date: Wed, 04 Feb 2004 21:57:18 -0500 From: MoPar Man <MoPar@Man.com> Newsgroups: rec.autos.makers.chrysler Called the dealer to make sure they had the part(s). Old part is in the box (I asked for it). Was asked if I had extended waranty (nope). I asked how much that cost (when car was new) - he sez between $2k and $3k. Cost of part: $139.70 ($105 USD) Labor: $123 ($92 USD) This is part # 04574023-AE The latch and solenoid is one (compact) unit. 4-pin connector. 3 separate clevices for connecting 3 control rods (1 for lock button, 1 for door handle, and the other for ???). Next time I have a problem I'll take this old one apart and see what's going on inside.
		Add comment


Bill Putney 24 April 2005 21:44:19 [ permanent link ]
	I definitely agree with MoPar man - the screeching is a dead giveaway that it is a bad lock motor - common failure on the LH's, and it is built into the latch. Remove door panel, unhook linkages and the small electrical connector at the latch. The latch is held in by the three large phillips flat-head screws that you see in the end of the door. Bill Putney (To reply by e-mail, replace the last letter of the alphabet in my adddress with the letter 'x') MoPar Man wrote: Dan wrote:> I am getting ready to rip into the passenger door and fix a >>problem with the power door lock.>> The problem I have is the door will not unlock, but does lock>>when the button is pushed. During the lock/unlock selections,>>a loud "screeching" sound comes from the door. > See my posts in rec.autos.makers.chrysler between Jan 31 to Feb 4,> 2004.> I have a 2000 300M, and initially my rear driver-side door couldn't be> unlocked or opened for a few days. Someone mentioned a child safety> lock may have inadvertently been engaged, but that was no the case. > It became operational on it's own a few days later, then one day> during it's normal auto-locking behavior it buzzed real loud and I> practically jumped out of my skin when it happened. Took it to a> dealer and got it replaced:> Here is an exerpt:> Subject: Re: Chrysler 300M: Can't open rear passenger door> Date: Wed, 04 Feb 2004 21:57:18 -0500> From: MoPar Man <MoPar@Man.com>> Newsgroups: rec.autos.makers.chrysler> Called the dealer to make sure they had the part(s).> Old part is in the box (I asked for it).> Was asked if I had extended waranty (nope). I asked how much> that cost (when car was new) - he sez between $2k and $3k. > Cost of part: $139.70 ($105 USD)> Labor: $123 ($92 USD)> This is part # 04574023-AE> The latch and solenoid is one (compact) unit. 4-pin connector.> 3 separate clevices for connecting 3 control rods (1 for lock> button, 1 for door handle, and the other for ???). Next time> I have a problem I'll take this old one apart and see what's > going on inside.
		Add comment


Dan 25 April 2005 03:44:52 [ permanent link ]
	Thanks guys, I will proceed to get the part and start the repair. I'll let you all know how it goes. Thanks much. "Bill Putney" <bptn@kinez.net> wrote in message news:d4gm1h$7up$1@news.isdn.net...> I definitely agree with MoPar man - the screeching is a dead giveaway that > it is a bad lock motor - common failure on the LH's, and it is built into > the latch. Remove door panel, unhook linkages and the small electrical > connector at the latch. The latch is held in by the three large phillips > flat-head screws that you see in the end of the door.> Bill Putney> (To reply by e-mail, replace the last letter of the alphabet in my > adddress with the letter 'x')> MoPar Man wrote:> Dan wrote:>> I am getting ready to rip into the passenger door and fix a problem with >>>the power door lock.>>> The problem I have is the door will not unlock, but does lock>>>when the button is pushed. During the lock/unlock selections,>>>a loud "screeching" sound comes from the door.>> See my posts in rec.autos.makers.chrysler between Jan 31 to Feb 4,>> 2004.>> I have a 2000 300M, and initially my rear driver-side door couldn't be>> unlocked or opened for a few days. Someone mentioned a child safety>> lock may have inadvertently been engaged, but that was no the case. It >> became operational on it's own a few days later, then one day>> during it's normal auto-locking behavior it buzzed real loud and I>> practically jumped out of my skin when it happened. Took it to a>> dealer and got it replaced:>> Here is an exerpt:>> Subject: Re: Chrysler 300M: Can't open rear passenger door>> Date: Wed, 04 Feb 2004 21:57:18 -0500>> From: MoPar Man <MoPar@Man.com>>> Newsgroups: rec.autos.makers.chrysler>> Called the dealer to make sure they had the part(s).>> Old part is in the box (I asked for it).>> Was asked if I had extended waranty (nope). I asked how much>> that cost (when car was new) - he sez between $2k and $3k. Cost of part: >> $139.70 ($105 USD)>> Labor: $123 ($92 USD)>> This is part # 04574023-AE>> The latch and solenoid is one (compact) unit. 4-pin connector.>> 3 separate clevices for connecting 3 control rods (1 for lock>> button, 1 for door handle, and the other for ???). Next time>> I have a problem I'll take this old one apart and see what's going on >> inside.
		Add comment




Get comments by e-mail Add to favourites

respect your talk pals, avoid using obscene language, typing entire messages in CAPS, posting buy/sell ads or violating netiquette or the RF Criminal Code..

	see also: GT4 bogging. NASCAR-CUP: Joe Gibbs Racing Charlotte… CHAMPCAR: Sebring Open Test practice 6…		pass tests:		see also: Pink Slip! 89 VW JETTA - Fuel Pump Relay Peugeot 307 Brakes

99 Intrepid Door Locks

Add new comment